| Numéro |
MATEC Web of Conferences
Volume 12, 2014
FDMD II - JIP 2014 - Fatigue Design & Material Defects
|
|
|---|---|---|
| Numéro d'article | 04015 | |
| Nombre de pages | 3 | |
| Section | Poster Session 4C: Fatigue Crack Initiation and Growth | |
| DOI | https://doi.org/10.1051/matecconf/20141204015 | |
| Publié en ligne | 9 juin 2014 | |
Fracture mechanics in new designed power module under thermo-mechanical loads
1 Robert Bosch GmbH, Automotive Electronics, 72762 Reutlingen, Germany
2 LAMIH UMR CNRS 8201, 59313 Valenciennes Cedex 9, France
3 Fraunhofer IZM, 13355 Berlin, Germany
a Corresponding author: camille.durand@de.bosch.com
Thermo-mechanically induced failure is a major reliability issue in the microelectronic industry. On this account, a new type of Assembly Interconnected Technology used to connect MOSFETs in power modules has been developed. The reliability is increased by using a copper clip soldered on the top side of the chip, avoiding the use of aluminium wire bonds, often responsible for the failure of the device. Thus the new designed MOSFET package does not follow the same failure mechanisms as standard modules. Thermal and power cycling tests were performed on these new packages and resulting failures were analyzed. Thermo-mechanical simulations including cracks in the aluminium metallization and intermetallics (IMC) were performed using Finite Element Analysis in order to better understand crack propagation and module behaviour.
© Owned by the authors, published by EDP Sciences, 2014
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.