| Numéro |
MATEC Web of Conferences
Volume 12, 2014
FDMD II - JIP 2014 - Fatigue Design & Material Defects
|
|
|---|---|---|
| Numéro d'article | 04004 | |
| Nombre de pages | 3 | |
| Section | Poster Session 4A: Fatigue and Defects | |
| DOI | https://doi.org/10.1051/matecconf/20141204004 | |
| Publié en ligne | 9 juin 2014 | |
Influence of casting defects on fatigue strength of an investment cast Ti-6Al-4V alloy
1 Institut Pprime, CNRS UPR 3346, ISAE-ENSMA, Université de Poitiers, Département Physique et Mécanique des Matériaux, Téléport 2, 1 avenue Clément Ader, BP. 40109, 86961 Futuroscope Chasseneuil Cedex, France
2 Airbus, Saint Martin du Touch, France
The influence of casting defects on fatigue strength of an investment cast Ti-6Al-4V alloy is investigated. The most common of these defects are: pinhole, linear defect and inclusion. Each of them is currently defined by its size, morphology and position from the surface but is different from each other for a same type. An experimental campaign is defined with different types of defect. The first part of the campaign is focused on the influence of an artificial and spherical defect, considering two different surface conditions. It is shown that fatigue behaviour of this alloy is very sensitive to the surface condition of this artificial defect despite stress concentrations at the tip of the defect. The second part of the campaign is focused on casting defects: reduction of fatigue life is quantified and it is shown that an electro-discharge machined defect cannot be representative of pinhole.
© Owned by the authors, published by EDP Sciences, 2014
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.